Network Power Ampacity Clarification
I'm sure it's just a typo, but "Section 9 Network Power" subsection "c" states:
c) Maximum current per conductor over network trunk cable according to wire gauge and network bus length shall not exceed specifications in table 9.1 and shall comply with “ANSI/RVIA Standard for Low Voltage Systems in Conversion and Recreational Vehicles[1]”.
Which is just fine, except there is no table 9.1 in the existing spec.
So, I'm assuming I can use normal wire ampacity tables?
Regards,
Tuesday, October 21, 2008 | 12:25pm
Please Sign in to View
Log in to view member-only content.
If you believe you are receiving this message in error contact us at memberservices@rvia.org.
Martin Perlot Member for 2 months 2 weeks
Frankly, I think the text should be expunged. Compliance with ANSI standards is implicit in being installed in an RV.
Martin Perlot Member for 2 months 2 weeks
I entirely agree. Let's consider this a formal proposal to remove the indicated verbiage.