Power Group : AC Point

From the Power Group,

Edits and Profiles for AC Points.

The AC_POINT DGNs apply to a number of different products, including transfer switches, gensets, inverters, and others. The test profiles apply to these products as well. In this document, the tests have been given the prefix 02, rather than a specific DSA. This is simply a placeholder, and in actual use the tests shall be numbered per the DSA of the device the test is being applied to. The Adminstrator shall indicate this in the final document.

Monday, February 24, 2020 | 16:44pm
You must be logged in to comment. Log in
1 comment

kcameron Member for 6 years 3 months

Should there be any alarms? I have used alarms in the solar section to indicate change of state or faults as follows. 1 History cleared 2 High solar voltage limit 100 Solar charge controller enabled 101 Solar charge controller disabled 102 Solar charge controller over temperature 103 Solar controller configuration changed 104 Solar controller configuration 2 changed 105 Solar controller configuration 3 changed 106 Solar controller configuration 4 changed 107 Solar controller configuration 5 changed 108 Solar controller equalization configuration changed 110 Transition to bulk stage 111 Transition to absorption stage 112 Transition to Overcharge State 113 Transition to Equalize State 114 Transition to float stage 115 Transition to CC/CV Stage 116 Charging complete 119 Low battery warning 120 Low battery voltage limit 121 High battery voltage limit 122 Battery over temperature 123 Battery under temperature 124 Battery Disconnected